Hull #180; Westerbeke 33a with V drive Bob Gamble "Patience" Phone 908-303-8794 Fax 908-626-9628 Email BobLGamble@... In a message dated 4/30/2009 7:11:43...
Hi Marilyn Ooliekirra is hull # 164 powered by a Westerbeke 27. We have the triangle main sheeting system and I discovered this spring the top sheaves on the...
MICHAEL, LOOK AT GARHAUER OR HARKEN. I USED HARKEN, HAD TO REDRILL THE MOUNTING HOLES. WES ... Hi Marilyn Ooliekirra is hull # 164 powered by a Westerbeke 27....
Ah, engines. Last year I pulled the old Volvo MD11c. So now Marie #109 has a spanking new Yanmar 3YM30 hooked up to the rebuilt Walter v-drive. You folks with...
Use a Garhauer block. (You may have to buy them with the spring bases attached) Grind off the rivet on the old blocks reuse the springs and bases use a bolt...
Gary I thought about that approach, but was not sure about where to locate a comparable sheave. Sounds like a simple plan that I might be able to accomplish...
Michael - We had exactly the same problem last year. We couldn't find matching base plates for new fiddle blocks. We cut the existing blocks off with a...
Hull 139 - Sheldon Warfield - Repowered in 2008 with a Westerbeke 44B four and v drive original engine was a westerbeke 33 and v drive ... how I can do it...
Go Away, #184, Westerbeke 42B4 (installed by PO in 1999). No problem with burying the stern, but when I want to maintain good speed in strong headwinds and...
Hi Everyone, I have my rudder shaft on a machinists table and it is out of round by 30/1000" (about 1/32") between the two bearing surfaces. Any comments on...
Barry, perhaps this follow-up to your rudder question will bring the issue to attention again. No response may mean that others agree with your comment "no...
For anyone still contemplating davits vs "Dinghy Tow" vs dinghy on deck, here is a comment from Ken and Lynn's latest posting in the Bahamas (about to return...
I agree, The dinghy should be brought on board.. The davits will not work if you use a windvane... michael 24 girl on the moon ... From: Darvin/Marilyn...
Sheldon, We looked at the 44B at the boat show. The injectors are on the port side of the engine rather then the starboard side as on my w-46. Do you think...
Thanks, Jerry Henry _____ From: niagara35sailboatowners@... [mailto:niagara35sailboatowners@...] On Behalf Of Jerry Raven Sent:...
Henry Williams
henryww@...
May 6, 2009 3:11 pm
403
Our entry is perfect, Marilyn. By the way, we're one of the last "classics" at hull 183 and I see that 187 is an "encore." Do you know which was the last...
Someone told me that the numbers are not exactly sequential. About 6 years ago we met the owner of the first Encore but at the time were not keeping track of...
I believe that is the case. I know of one couple who bought two new classics . They were several years and many miles apart. They loved the design. cheers ...
